Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Upon Arrival Found Furnace Making Humming Noise. Upon Further Investigation Found Blower Motor Capacitor Failed. Replaced Capacitor. Cycled Furnace To Insure Proper Operation. Furnace Is Heating Properly At This Time With A Temperature Rise Of 50°. Checked Heat Exchangers Finding No Failures At This Time. Completed Carbon Monoxide Test Finding 0ppm At This Time. Cleaned Drain Lines, Condensate Trap And Flame Sensor As Preventative Maintenance. Customer Would Like Receipt In The Mail.
LAPORTE, IN
01-15-2021
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call For Furnace Short Cycling. Upon Arrival Cycled Furnace Through Low And High Stages And Unit Is Running Properly. Cleaned Condensate Trap And Flame Sensor As A Preventative Measure. Inspected Primary And Secondary Heat Exchangers And Found No Failures At This Time. Found Thermostat Inaccurate. Replaced Thermostat And Observed Unit Operation. Unit Is Heating Properly At This Time With A Temperature Rise Of 43° On Low Stage And 51° On High Stage.
LAPORTE, IN
01-07-2021
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call For Furnace Short Cycling. Upon Arrival Found T Cycling To Pressure Switch Fault. Inspected Inducer Motor Vacuum And Inducer Signal Port. After Further Investigation Found Pressure Operating Intermittently. Replaced Pressure Switch Assembly And Cycled Furnace To Ensure Proper Operation. Unit Is Heating Properly At This Time.
LaPorte, IN
12-29-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call For Intermittent Heat. Upon Arrival Found Thermostat Satisfied At 74°. Client Stated That Unit Intermittently Meets Thermostat Set Point. After Further Investigation Found Flame Sensor Micro Amps At .5. Cleaned Flame Sensor And Measured 4.9 Micro Amps. Also Cleaned Condensate Trap As A Preventative Measure. Cycled Furnace To Ensure Proper Operation And Unit Is Heating Properly At This Time With A Temperature Rise Of 48° On Low Stage And 55° On High Stage. Recommend Having Furnace Serviced Annually For Preventative Maintenance Purposes.
LAPORTE, IN
12-18-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call To Perform USP Furnace Service. Upon Arrival Inspected Primary And Secondary Heat Exchanger Assemblies And Found Minor Failures In Multiple Primary Cells. Also Found Bearings Weak On Inducer Motor Assembly. (Model #353BAV060100) Explained To Client Of The Potential Dangers Of Carbon Monoxide If The Furnace Is Used And Advised Not To Operate. Need To Contact Client With Repair Options As Soon As Possible. 12/9/20 Replaced Primary Heat Exchanger Cells Under Factory Parts Warranty. Also Performed USP Furnace Service Per Member Agreement. Cleaned Burners, Cleaned Flame Sensor, Cleaned Condensate Trap, Measured Igniter Resistance At 52 Ohms, Inspected Blower Wheel, Inspected Evaporator Coil, Replaced Client Supplied Air Filter And Cycled Furnace To Ensure Proper Operation. Unit Is Heating Properly At This Time With A Temperature Rise Of 49 Degrees.
LaPorte, IN
12-16-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call For Furnace Making Noise. Upon Arrival Found Failed Capacitor And Failed Blower Motor. Inspected Heat Exchangers And Found No Failures At This Time. Replaced Blower Motor And Capacitor, Cleaned Flame Sensor As A Preventative Measure And Cycled Furnace To Ensure Proper Operation And Unit Is Heating Properly At This Time With A Temperature Rise Of 54 Degrees.
LAPORTE, IN
12-10-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call For Furnace Operating Only On Low Stage Of Heating. Upon Arrival Cycled Furnace On High Fire And Observed Unit Operate Properly. Removed Inducer Motor And Drained Water From Inducer Housing, Cleaned Condensate Trap, Inspected Heat Exchanger Assemblies And Cleaned Flame Sensor As A Preventative Measure. Performed Dealer Service Bulletin DSB 14-0004. Enlarged Pressure Switch Port To 3/16” Per Bulletin And Cycled Furnace In Low And High Stages Of Heat To Ensure Proper Operation. Furnace Is Heating Properly At This Time With A Temperature Rise Of 51° On Low Stage And 64° On High Stage.
LaPorte, IN
12-10-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call To Replace Control Board On Armstrong Furnace. Replaced Control Board And Air Filter. Cycled Furnace To Ensure Proper Operation And Performed A Carbon Monoxide Test. Unit Is Heating Properly At This Time With A Temperature Rise Of 52 Degrees And Is Emitting No Carbon Monoxide Gases At This Time.
LaPorte, IN
10-29-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Serviced Furnace For The Upcoming Heating Season. Cleaned Burners, Cleaned Flame Sensor, Cleaned Condensate Trap, Measured Igniter Resistance At 78 Ohms, Inspected Blower Wheel, Air Filter And Primary And Secondary Heat Exchangers. Cycled Furnace To Ensure Proper Operation And Unit Is Heating Properly At This Time With A Temperature Rise Of 59°. Performed A Carbon Monoxide Test And Unit Is Emitting No Carbon Monoxide Gases At This Time.
LAPORTE, IN
10-29-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call For Furnace Making Noise. Upon Arrival Found Furnace Inducer Motor Grommets Out Of Adjustment. Adjusted Motor Grommets, Cleaned Flame Sensor As A Preventative Measure And Cycled Furnace To Ensure Proper Operation. Unit Is Heating Properly At This Time With A Temperature Rise Of 56 Degrees.
LAPORTE, IN
10-29-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call For No Heat. Upon Arrival Found Furnace Displaying Fault Code 31 For Pressure Switch Fault. Cleared All Drain Lines, Cleared Condensate Trap, And Found Switch Operating Intermittently. Replaced Pressure Switch, Replaced Client Provided Air Filter, And Cleaned Flame Sensor As A Preventative Measure. Cycled Furnace To Ensure Proper Operation And Unit Is Heating Properly At This Time With A Temperature Rise Of Degrees.
LaPorte, IN
10-20-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call For No Heat. Upon Arrival Found Limit Tripped. After Further Investigation Found Air Filters Recently Replaced. Re-set Furnace And Replaced Failed Blower Motor Capacitor. Cycled Furnace To Ensure Proper Operation And Unit Is Heating Properly At This Time With A Temperature Rise Of 60°. Recommended Replacing Air Filters More Often To Help Prevent Nuisance Limit Trips.
LAPORTE, IN
10-12-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Callback For No Heat After Furnace Service. Upon Arrival Found Pilot Light Out. Re-lit Pilot And Cycled Furnace To Ensure Proper Operation. Found Thermocouple Slightly Out Of Adjustment. Re-positioned Thermocouple And Furnace Is Heating Properly At This Time.
LAPORTE, IN
10-12-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call To Inspect Clients Filter Slot For Enter Ease Of Access. Replaced Client Supplied Air Filter And Gathered Information To Re-configure The Filter Access.
LAPORTE, IN
09-28-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call For Flame Rollout During Furnace Operation. Upon Arrival Found Furnace Ignition Components Disconnected And Gas Off To The Appliance. Re-assembled Unit And Found Failed Inducer Motor With Flame Rollout. Inspected Primary Heat Exchanger Cells And Found Pin Holes In The Heat Exchanger. Shut Appliance Gas Supply Stop Off And Advised Homeowner Not To Operate The Furnace Due To The Potential For Carbon Monoxide Gases. Gathered Information To Provide An Estimate For A Replacement Furnace.
LAPORTE, IN
09-28-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call For Furnace Short Cycling. Upon Arrival Cycled Unit From The Thermostat And Found Control Board Malfunctioning. Inspected Heat Exchanger Assembly And Found No Failures At This Time. Replaced Control Board And Cycled Furnace To Ensure Proper Operation. Unit Is Heating Properly At This Time With A Temperature Rise Of 55 Degrees.
LAPORTE, IN
09-28-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call For No Heat. Upon Arrival Found Thermostat Calling For Heat With No Furnace Operation. After Further Investigation Found Loose Wiring Connection At Furnace Control Board. Secured Connection And Cycled Furnace. Also Serviced Furnace Per Clients Request. Cleaned Burners, Cleaned Flame Sensor, Cleaned Condensate Trap, Measured Igniter Resistance At 74 Ohms, Inspected Blower Wheel, Inspected Evaporator Coil, Replaced Client Provided Air Filter And Inspected Primary And Secondary Heat Exchangers With No Failures At This Time. Performed A Carbon Monoxide Test And Unit Is Heating Properly At This Time With A Temperature Rise Of 56 Degrees.
LAPORTE, IN
09-28-2020
Furnace Service And Repair Laporte, Indiana
Technician Invoice Notes: Call For No Heat. Upon Arrival Found Thermostat Calling For Heat With No Low Voltage. After Further Investigation Found Failed Transformer. Client Had Switched To A/C On The Thermostat Recently And The Furnace Never Came Back On. Found Rodent Chewed Wired At Outdoor Condenser. Repaired Low Voltage Wiring And Re-sealed Line Set Hole. Inspected Furnace Heat Exchanger And Found The Primary Cells Failed. Performed A Carbon Monoxide Test And Unit Is Emitting No Carbon Monoxide At This Time. Highly Recommended Client To Replace Furnace Due To The Potential For Carbon Monoxide Gases.
LaPorte, IN
04-11-2020
